Engine mounts
Yesterday I re-made the engine mounts. I replaced the solid steel mounts with some polyurethane mounts. More specifically ENS-3-1114G
Sunday, May 13, 2007
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Also done this weekend was the Power Steering pressure line. This I thought turned out really well. It was my first time making a cu... -
After a delay due to vacation I was able to get some more done. This week I mounted the PCM into the pocket in the firewall where the BMW ha... -
Wow, a lot has happened since my last post. Due to trips and Internet problems I have gotten behind. Here is the update: I finished my fuel ... -
Finally the last fitting I needed to complete my remote bleed line showed up on the 14th. After weeks of being on back order I finally recie... -
OK. Been busy working on the project and doing research so I haven't done much posting. Last week I mapped out the the engine wire harne... -
Project will be going a different direction. Sold my ls1 and t56 today. Time to dust off my electric car parts and get that project on ... -
Well I'm not very good at keeping things updated. Last weekend I pulled the BMW motor. All and all it went fairly well and wasn't to... -
Installed the sport steering wheel today. Bought it used and when I got it part of the rim was rough looking. Bit worn and sort of loo... -
After some more delays due to having to repair my tractorys Hydroic pump and also a computer hard drive crash taking my time I was finally a...
LS1 BMW
1 comment:
Post a Comment